2078 ROUNDOVER & EDGE TRIM Shaper Cutters Light socket incorporated into drill

Light socket incorporated into drill press head (standard light bulb not included)

Comfortable 2K composite handle with inserts permits comfortable ergonomic operation

miter gauge and precision TRU-RIP aluminum rip fence with resaw guide included

Pre-drilled holes are 16" on center for simple mounting to wall studs

tilt angle adjust +/- 45/90 degrees

2078 ROUNDOVER & EDGE TRIM Shaper Cutters Light socket incorporated into drill1 2"SH, 3 8"R, 1 3 8"LD, 1 2"SD Product Description Plunge Roundovers can cut a flat bottom while providing that traditional roundover edge. These bits can also be used to cut out your project, leaving only the traditional roundover edge on the side of your workpiece.